Soaps Gone Buy - Where Soaps of yesterday are found Today!

Home > Soaps >

Fels Naptha 24/CASE Price

24 Bars $35.00
Sale Price: $23.76
You Save $11.24!

Manufacturer: DIAL Corporation

Qty:

Description

MSDS

Specialty Uses and Recipes

Page 1 of 4
MATERIAL SAFETY DATA SHEET
MSDS L-101 REVISION 6
---------------------------------------------------------------------------------------------------------------------------------------------------------------
DISTRIBUTED BY:
THE DIAL CORPORATION
CENTER FOR INNOVATION MEDICAL EMERGENCIES: 1-888-689-9082
15101 NORTH SCOTTSDALE ROAD CHEMTREC: 1-800-424-9300 (24 Hours Daily)
SCOTTSDALE, ARIZONA 85254-9934 OTHER INFORMATION: 1-888-468-6673
SUBSTANCE IDENTIFICATION
SUBSTANCE: HEAVY DUTY LAUNDRY BAR SOAP
TRADE NAMES/SYNONYMS: FELS NAPTHA - HEAVY DUTY LAUNDRY BAR SOAP
CHEMICAL FAMILY: Mixture
I.D. NUMBERS: 904439
NFPA RATINGS (Scale 0-4, where 4=high degree of hazard): HEALTH=1 FLAMMABILITY=1 REACTIVITY=0
HMIS RATINGS (Scale 0-4, where 4=severe hazard): HEALTH=1 FLAMMABILITY=1 REACTIVITY=0
This product is labeled in accordance with regulations administered by the Consumer Product Safety Commission. The
use pattern and exposure in the workplace are generally not consistent with those experienced by consumers. The
requirements of the Occupational Safety and Health Administration applicable to this Material Safety Data Sheet differ
from the requirements of the CPSC and as a result, this MSDS may contain additional health hazard information not
pertinent to consumer use and not found on the product label.
HAZARDOUS INGREDIENT INFORMATION
COMPONENT: SODIUM SOAP CAS# 67701-11-5 & 67701-10-4
SOAP DUST = PARTICULATES NOT OTHERWISE CLASSIFIED (PNOC):
15 mg/m3 OSHA TWA (total dust); 5 mg/m3 OSHA TWA (respirable fraction)
10 mg/m3 ACGIH TWA (total dust); 3 mg/m3 ACGIH TWA (respirable fraction)
COMPONENT: HYDROCARBONS, TERPENE PROCESSING BY-PRODUCTS CAS# 68956-56-9
Carcinogen status of components: Not listed as carcinogenic by NTP, IARC, or OSHA.
PHYSICAL AND CHEMICAL DATA
DESCRIPTION: Tan or brown bar. SOLUBILITY IN WATER: Nearly complete.
FIRE AND EXPLOSION DATA
FIRE AND EXPLOSION HAZARD - The fire hazard for this product has not been determined. The hazard(s) of the
component(s) with the most severe hazard(s) are:
Slight fire hazard when exposed to heat or flame.
FIRE FIGHTING MEDIA - Dry chemical, carbon dioxide, water spray or regular foam. For larger fires, use water spray, fog
or regular foam.
FIRE FIGHTING - Do not scatter spilled material with high - pressure water streams. Dike fire-control water for later
disposal. Use agents suitable for type of surrounding fire. Avoid breathing hazardous vapors, keep upwind.
MSDS L-101 (Rev. 6
Page 2 of 4
HEALTH HAZARD DATA
NOTE: The acute health effects described below are those which could potentially occur for the finished product. They
are based on the toxicology information available for the finished product and/or each hazardous ingredient, and are
consistent with the product type and the likelihood of a specific route of exposure. Known chronic health effects related to
exposure to a specific ingredient are indicated.
ACUTE HEALTH EFFECTS:
INHALATION: Dust may cause mild irritation of the mucous membranes.
SKIN CONTACT: May cause irritation with drying, redness, and cracking due to the
defatting action on the skin. Dermatitis may result from repeated or prolonged contact.
EYE CONTACT: May cause irritation.
INGESTION: Ingestion may cause irritation of the throat and gastrointestinal tract, nausea, vomiting, and
diarrhea. Aspiration into the lungs could possibly occur causing chemical pneumonitis and
pulmonary edema.
CHRONIC HEALTH EFFECTS: None known.
MEDICAL CONDITIONS GENERALLY RECOGNIZED AS BEING AGGRAVATED BY EXPOSURE: Pre-existing
skin conditions.
EMERGENCY AND FIRST AID PROCEDURES
INHALATION: Immediately remove from exposure area to fresh air. Keep affected person warm and at rest. Treat
symptomatically and supportively. Contact physician or local poison control center. If breathing has stopped, give
artificial respiration, and get medical attention immediately.
SKIN CONTACT: Rinse affected area with plenty of water until no evidence of product remains. Get medical
attention if irritation persists.
EYE CONTACT: Immediately rinse eyes with plenty of water, occasionally lifting upper and lower lids, until no
evidence of product remains. Get medical attention if pain or irritation persist.
INGESTION: Immediately get medical attention. DO NOT induce vomiting. Treat symptomatically and supportively.
Maintain airway and respiration. If vomiting occurs, keep head below hips to prevent aspiration. Dilution by rinsing
the mouth and giving water or milk to drink is generally recommended. If unconscious, the victim should not be given
anything to drink.
REACTIVITY
REACTIVITY - Stable under normal temperatures and pressures.
INCOMPATIBILITIES: Strong oxidizers, acids, bases, chlorine.
DECOMPOSITION - Thermal decomposition may release toxic and/or hazardous gases.
POLYMERIZATION - Hazardous polymerization has not been reported to occur under normal temperatures and
pressures.
STORAGE AND DISPOSAL
MSDS L-101 (Rev. 6
Page 3 of 4
Store away from incompatible substances. Observe all federal, state and local regulations when storing or disposing of
this substance.
CONDITIONS TO AVOID
May burn but does not ignite readily. Avoid contact with incompatible substances and excessive heat.
SPILL AND LEAK PROCEDURES
OCCUPATIONAL SPILL - Sweep up and place in suitable clean, dry containers for reclamation or later disposal. Do not
flush spilled material into sewer. Keep unnecessary people away.
OCCUPATIONAL PROTECTIVE EQUIPMENT
VENTILATION - Provide local exhaust ventilation to meet permissible exposure limits where generation of dust is likely to
occur.
RESPIRATOR - Air contamination monitoring should be carried out where generation of dust is likely to occur to assure
that the employees are not exposed to harmful concentrations exceeding permissible exposure limits. If respiratory
protection is required, it must be based on the contamination levels found in the workplace, must not exceed the working
limits of the respirator and be jointly approved by the National Institute for Occupational Safety and Health and the Mine
Safety and Health Administration (NIOSH-MSHA).
FOR FIRE FIGHTING AND OTHER IMMEDIATELY DANGEROUS TO LIFE OR HEALTH CONDITIONS -
Any self-contained breathing apparatus that has a full facepiece and is operated in a pressure-demand or other positivepressure
mode. Any supplied-air respirator that has a full facepiece and is operated in a pressure-demand or other
positive-pressure mode in combination with an auxiliary self-contained breathing apparatus operated in pressuredemand
or other positive-pressure mode.
CLOTHING - Protective clothing is required where repeated or prolonged skin contact may occur.
GLOVES - Chemical-resistant gloves are required where repeated or prolonged skin contact may occur.
EYE PROTECTION - Dust-proof safety glasses are required to prevent eye contact where dusty conditions may occur.
REGULATORY INFORMATION
DOT FLAMMABILITY CLASSIFICATION: Not applicable.
EPA - SARA TITLE III SECTION 313: Not applicable - Consumer product.
TSCA: All components of this product are listed or are exempted or
excluded from listing on the U.S. Toxic Substances Control Act
(TSCA) chemical substance inventory.
MSDS L-101 (Rev. 6
Page 4 of 4
---------------------------------------------------------------------------------------------------------------------------------------------------------------
The information contained herein is provided in good faith and is believed to be correct as of the date hereof. However,
the Dial Corporation makes no representation as to the comprehensiveness or accuracy of the information. It is expected
that individuals receiving the information will exercise their independent judgment in determining its appropriateness for a
particular purpose. Accordingly, the Dial Corporation will not be responsible for damages of any kind resulting from the
use of or reliance upon such information. No representations, or warranties, either expressed or implied of
merchantability, fitness for a particular purpose or of any other nature are made hereunder with respect to the information
set forth herein or to the product to which the information refers.
---------------------------------------------------------------------------------------------------------------------------------------------------------------
MSDS CREATION DATE: 02/10/94
SUPERSEDES: Rev. 5, 12/12/97
REVISION DATE: 10/26/98
REVISION: Update Substance Identification I.D. Number, Hazardous Ingredient Information and Health Hazard Data.